• Assembled products may not be manipulated or improperly opened.
• Ensure that the protective or functional ground has been properly connected.
• Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards.
• For operating voltages > 50 V AC, conductive connector housings must be grounded
• Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products).
• Only use tools recommended by Phoenix Contact
• Operate the connector only when it is fully plugged in and interlocked.
• The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12).
• The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product.
• The products are suitable for applications in plant, controller, and electrical device engineering.
• Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products
• VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are applicable when combining several circuits in a cable and/or connector
• WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible.
• When operating the connectors in outdoor applications, they must be separately protected against environmental influences.
• When using the product in direct connection with third-party manufacturers, the user is responsible.
WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property.