Naudojimo pastabos
The PLC-ATP partition plate must be installed for voltages greater than 250 V (L1, L2, L3) between identical terminal blocks on adjacent modules.
The PLC-ATP separating plate should be installed for safe isolation between adjacent modules
The system installer must ensure the touch protection of the product (at voltages > 25 V AC/60 V DC). The product is a built-in device without protection against direct contact.
Montavimo pastaba
in rows with zero spacing
The PLC-ATP separating plate is required at the start and end of every PLC terminal strip.
Tipinė įėjimo srovė esant UN
10 mA (60 Hz)
8.5 mA (50 Hz)
Pritaikymas
Filter to prevent interference
Mechaninis tarnavimo laikas
Paskutinio duomenų tvarkymo data
Maksimali galios išsklaida nominaliomis sąlygomis
Bandymo įtampa (apvija/kontaktas)
4 kVrms (50 Hz, 1 min., winding/contact)
Nominali izoliacijos įtampa
Nominali viršįtampio įtampa
4 kV (Safe isolation, reinforced insulation, and 6 kV between input circuit and output contact current paths)
Vardinė įėjimo įtampa U N
Įėjimo įtampos diapazonas
171.6 V DC ... 253 V DC (20 °C)
179.4 V AC ... 264.5 V AC (20 °C)
Vardinė įtampa (prijungtas elektromechaninis relė)
Tipinė įėjimo srovė esant U < sub > N < /sub >
10 mA (60 Hz)
8.5 mA (50 Hz)
Apsauginė grandinė
Bridge rectifier
RC element
Kontaktų perjungimo tipas
Maksimali perjungimo įtampa
Minimali perjungimo įtampa
Ribojamas nuolatinis srovės stipris
10 A (value applies to connections 12. If connections 12 are bridged, the normal value applies.)
6 A
Maksimali įjungimo srovė
30 A (300 ms, N/O contact)
Maks. pertraukimo galia (omine apkrova)
144 W (24 V DC)
1500 VA (250 V AC)
240 W (24 V DC, value is valid for connections 12. If connections 12 are bridged, the normal value applies.)
2500 W (250 V AC, value is valid for connections 12. If connections 12 are bridged, the normal value applies.)
48 W (60 V DC)
50 W (110 V DC)
58 W (48 V DC)
80 W (220 V DC)
Perjungimo galia
0.2 A (DC13, 250 V)
2 A (DC13, 24 V)
6 A (AC15, 24 V)
6 A (AC15, 250 V)
Izoliacijos nuėmimo ilgis
Laido skerspjūvio plotas (fiksuotas)
Lankstaus laidininko skerspjūvis
0.14 mm² ... 2.5 mm²
0.2 mm² ... 2.5 mm² (Single ferrule)
2x 0.5 mm² ... 1.5 mm² (TWIN ferrule)
Prisukimo sukimo momentas