Input voltage range in reference to UN
Typical input current at UN
Environment
Attached to the vehicle body
Date of last data management
Maximum power dissipation for nominal condition
Test voltage (Winding/contact)
5 kVrms (50 Hz, 1 min., winding/contact)
Test voltage (Changeover contact/changeover contact)
2.5 kVrms (50 Hz, 1 min., changeover contact/changeover contact)
Input voltage range in reference to UN
Nominal voltage (plugged-in electromechanical relay)
Typical input current at UN
Protective circuit
Bridge rectifier
RCZ filter
Surge protection; Freewheeling diode
Wide-range electronics
Operating voltage display
Maximum switching voltage
250 V AC/DC (Separating plate PLC-ATP must be installed for voltages larger than 250 V (L1, L2, L3) between identical terminal blocks in adjacent modules.)
30 V AC
36 V DC
Minimum switching voltage
Limiting continuous current
Interrupting rating (ohmic load) max.
1.2 W (at 24 V DC)
100 W (at 48 V DC)
140 W (at 24 V DC)
1500 VA (for 250 V AC)
44 W (at 110 V DC)
60 W (at 220 V DC)
60 W (at 60 V DC)
Note
the following values are applicable if a gold layer is destroyed
Switching capacity
0.2 A (at 110 V, DC13)
0.2 A (at 250 V, DC13)
2 A (at 120 V, AC15)
2 A (at 24 V, AC15)
2 A (at 24 V, DC13)
2 A (at 250 V, AC15)
Conductor cross-section rigid
Conductor cross-section flexible
0.14 mm² ... 2.5 mm²
0.2 mm² ... 2.5 mm² (Single ferrule)
2x 0.5 mm² ... 1 mm² (TWIN ferrule)
Conductor cross-section AWG
Flammability rating according to UL 94 (Housing)